A laser profiler measures height, not brightness. DESSAR Digital Intelligence supplies 3D laser line profilers, proves them on your part, and builds the measuring station around them. We are the sales and service partner for LMI Technologies in India.
A laser profiler projects a line of laser light across the part and views it from an angle. The shape of the line on the imager gives a calibrated height for every point along it: one profile. As the part moves, the profiles stack into a full 3D surface. The method is laser triangulation.
It is the right choice for parts in motion and for anything defined by height: step, gap and flush, flatness, bead and weld volume, profile shape. For a part that stops, a 3D snapshot sensor captures the whole surface in one shot.
Supplied in India, selected against your application, and supported by the engineers who build the systems.
44 Gocator models across the 2100 to 2800 and 6300 series, with on-board measurement tools.
LMI Gocator in India →Every Gocator model with its published figures and a datasheet.
Open the catalogue →33 laser profile sensor models in the DP2000, DP3000 and DP4000 series.
Models and datasheets →Our own station software for 3D measurement and inspection with laser profilers.
See the product →DESSAR Digital Intelligence (DESSAR Systems India Private Limited, Pune) supplies, integrates and supports 3D laser line profilers across India. DESSAR is the sales and service partner for LMI Technologies, the maker of Gocator 3D smart sensors, in India.
They are the same sensor. One exposure gives a 2D profile, a cross-section of the part. With the part moving and an encoder connected, the profiles are stacked into a 3D surface.
It depends on the model and the field of view: the smaller the field, the finer the resolution. Height repeatability ranges from fractions of a micrometre on small-field sensors to tens of micrometres on wide-field sensors. The figure for your part is established in a trial.
Usually yes. Blue laser sensors handle machined and plated metal well, and exposure control handles dark rubber and plastic. Mirror-like and transparent surfaces need a confocal sensor instead.
Send the part, what must be seen or measured, and the line rate. We reply with the camera or sensor that fits and what it takes to put it on your line.