[ the Safety Vision
operator screen ]
DSR-SVS
Safety Vision
Watches a work cell for unsafe states and approach conditions, tied into the cell's own safety logic.
Solutions
Nine systems you can put on a line.
Each one started as somebody's inspection problem and became a product. Every card shows the screen your operator will actually use — open the live demo and try it, download the datasheet, or ask for a demonstration on your own part.
[ the PPE Inspector
portal screen ]
DSR-PPE
Safety PPE Inspector
Checks that helmets, vests, gloves and glasses are worn where they have to be, and keeps the record.
[ the Pin Count
inspection screen ]
DSR-PCI
Pin Count Inspector
Counts pins and needles and proves every one is present, at line rate, with the verdict handed to the machine.
[ the Terminal Block
recipe screen ]
DSR-TBV
Terminal Block Inspection
Verifies a DIN-rail terminal assembly against the master: sequence, colour, the markers read by eye, dimensions.
[ the Defect Inspection
Station screen ]
DSR-STN
Defect Inspection Station
Finds surface and cosmetic defects that no fixed rule describes, learnt from your own good and rejected parts.
[ the Bubble Leak
live view ]
DSR-BLT
Bubble Leak Detection
Watches a submerged part and calls the leak as it happens, instead of leaving it to an operator over the tank.
[ the Scope measure
and report screen ]
DSR-3DVS
3D Vision Scope
3D vision scope for measurement and inspection: the part in three dimensions, dimensions read off it, defects marked, and a report at the end.
[ the tunnel defect
map screen ]
DSR-TLI
Tunnel Lining Inspection
Autonomous capture along a tunnel, the defect map built as it goes and the chainage carried into the report.
[ the simulator
cell view ]
DSR-3DS
Simulator
The cell built in 3D before it is built in steel — reach, cycle and sightlines proved while they are still cheap to change.
We also supply what we build with
The same components, with the application advice that usually matters more than the part number.
None of these quite it?
Most of what we build was a one-off first. Send the part, the tolerance and the cycle time, and you will get an honest answer on what vision can and cannot do for it.